Torsion beam suspension
From WOI Encyclopedia Italia
Torsion beam suspension, also known as a torsion bar or torsion spring suspension, is a vehicle suspension system. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end terminates in a lever, mounted perpendicular to the bar, that is attached to the axle of the suspension arm or wishbone. Vertical motion of the wheel causes the bar to rotate along its axis and is resisted by the bar's torsion resistance. The effective spring rate of the bar is determined by its length, diameter, and material.
Torsion Bar Suspensions are currently used on trucks and SUV's from Ford, GM and Dodge. Manufacturers change the torsion bar or key to adjust the ride height, usually to compensate for heavier or lighter engine packages. While the ride height may be adjusted by turning the adjuster bolts on the stock torsion key, rotating the stock keys too far can bend the adjusting bolt and (more importantly) place the shock piston outside the standard travel. Over-rotating the torsion bars can also cause the suspension to hit the bump stop prematurely, causing a harsh ride. Aftermarket forged torsion key kits use re-clocked adjuster keys to prevent over-rotation, as well as shock brackets that keep the piston travel in the stock position.
The main advantages of torsion beam suspension are durability, easy adjustability of ride height, and small profile along the width of the vehicle. It provides a longer travel than leaf spring systems, and takes up less of the vehicle's interior volume compared to coil springs. A major disadvantage is that torsion bars, unlike coil springs, usually cannot provide a progressive spring rate, forcing designers to compromise between ride quality and handling ability - progressive torsion bars are available, but at the expense of durability since they have a tendency to crack where the diameter of the bar changes. In most torsion bar systems, especially Chrysler's, ride height (and therefore many handling features) may be adjusted by bolts which connect the torsion bars to the steering knuckles and require nothing more than crawling under the car with a wrench in hand. In most cars which use this type of suspension, swapping torsion bars for those with a different spring rate is usually an extremely easy task.
Some vehicles use torsion bars to provide automatic leveling, using a motor to tighten the bars to provide greater resistance to load and, in some cases (depending on the speed with which the motors can act), to respond to changes in road conditions. Height adjustable suspension has been used to implement a wheel-change mode where the vehicle is raised on three axles and the remaining wheel is lifted off the ground without the aid of a jack.
Before World War II, the front wheel drive Citroen Traction Avant (1934) had independent front torsion bar suspension and a trailing dead axle, also sprung by torsion bars. The Czechoslovakian Tatra cars designed by Professor Hans Ledwinka in the mid 1930s used all round independent torsion bar suspension, along with air cooled rear engines. Also in the 1930s, prototypes of the first Volkswagen Beetle incorporated torsion bars - especially its transverse mounting style. Ledwinka's concept had been copied by Ferdinand Porsche, whose successors later had to acknowledge the influence of Ledwinka's Tatra models on the Porsche-designed Kdf-Wagen of 1938 (later known as the VW Beetle), a post-war lawsuit resulting in a DM3,000,000 settlement paid by Volkswagen to Ringhoffer-Tatra in 1961.
The system was applied to many new armoured fighting vehicle designs during the Second World War. It was used extensively in European cars Renault, Citroen and Volkswagen, as well as by Packard in the 1950s. The Packard used torsion bars at both front and rear, and interconnected the front and rear systems to improve ride quality. The most famous American passenger-car application was the Chrysler system used beginning with the 1957 model year, although Chrysler's "Torsion-Aire" suspension was only for the front; the same basic system (longitudinal mounting) was maintained until the 1981 introduction of the K-car. A reengineered torsion beam suspension, introduced with the 1976 Dodge Aspen, introduced transverse-mounted torsion beams (possibly based on the Volkswagen Type 3 passenger car) until production ended in 1989 (with Chrysler's M platform). Light-duty Dodge trucks however continue to use torsion bars on their front suspension.
General Motors has used torsion bars since 1966, starting with the E-platform vehicles (Oldsmobile Toronado, Cadillac Eldorado), 4 wheel drive S-10 pickups, and since 1988, full size trucks (GMT400, GMT800, and GMT900 series).
Some front-wheel drive automobiles use a type of torsion bar suspension, usually called a Twist-beam rear suspension, in which the rear wheels are carried on trailing arms connected by a laterally mounted torsion beam. The torsion beam functions both as wheel-locating arm and as an anti-roll bar to resist lateral motion of the wheels as the body leans in turns. Its advantages are that it is inexpensive to manufacture and install, and engages a minimum amount of interior volume, leaving more space for the carriage of passengers, cargo, and other components. Because the torsion bar acts in the lateral plane, not vertically, the twist-beam axle cannot provide ride-height adjustment, and it suffers, to some extent, similar car handling limitations as other beam axle suspensions. However these limitations may not be apparent on the road, because of the trend towards firmer, more sporty suspension setups with more limited wheel travel. Twist-beam rear suspensions were pioneered on the Volkswagen GolfTemplate:Fact in the early 1970s, and remain common on compact cars and minivans.
External links
| Articles relating to Automobile configurations | |
|---|---|
| Car body style and classification | 2 plus 2 | Antique car | Cabrio coach | Cabriolet | City car | Classic car | Compact car | Compact performance car | Compact SUV | Convertible | Coupé | Coupé convertible | Coupe Utility | Crossover SUV | Custom car | Drophead coupe | Fastback | Full-size car | Grand tourer | Hardtop | Hatchback | Hot hatch | Hot rod | Large family car | Leisure activity vehicle | Liftback | Limousine | Luxury car | Microcar | Mid-size car | Mini SUV | Minivan | Multi-purpose vehicle | Muscle car | Notchback | Personal luxury car | Pickup truck | Retractable hardtop | Roadster | Sedan | Saloon | Small family car | Sport compact | Sports car | Sport utility vehicle | Spyder | Station wagon | Estate car | Supermini | Targa top | Taxicab | Touring car | Town car | T-top | Ute | Van | Voiturette |
| Specialised vehicles | Gyrocar | Flying car. Amphibious vehicle |
| Fuel technologies | Internal combustion engine | Electric vehicle | Neighborhood electric vehicle | Hybrid vehicle | Battery electric vehicle | Hydrogen vehicle | Fuel cell | Plug-in hybrid electric vehicle | Steam car | Alternative fuel cars | Biodiesel | Gasohol | Ethanol | LPG (Propane) | Homogeneous Charge Compression Ignition | Liquid Nitrogen | Gasoline Direct Injection |
| Driven wheels | Four-wheel drive | Front-wheel drive | Rear-wheel drive | All-wheel drive | Two-wheel drive |
| Engine positioning | Front engine | Rear engine | Mid engine |
| Layout | FF layout | FR layout | MR layout | MF layout | RR layout |
| Engine configuration | Internal combustion engine | Straight-6 | V engine | Wankel engine | Reciprocating engine | Inline engine | Flat engine | Flathead engine | Diesel engine | Two-stroke cycle | Four-stroke cycle | Pushrod engine | Straight engine | H engine | Turbodiesel | Hybrid vehicle | Rechargeable energy storage system | Electric vehicle | Hydrogen vehicle |
| Body | Framework | A-pillar | Bumper | Cabrio coach | Chassis | Crumple zone | Body-on-frame | Dagmar bumpers | Fender | Fender skirts | Grille | Hood | Hood scoop | Monocoque construction | Pontoon fenders | Quarter panel | Shaker scoop | Spoiler | Subframe | Tonneau |
| Doors | Butterfly doors | Gull-wing door | Scissor doors | Suicide door | |
| Glass | Sunroof | Greenhouse | Windshield | |
| Other | Antenna ball | Hood ornament | Japan Black paint | Nerf bar | Truck accessory | Bumper sticker | |
| Exterior Equipment | Lighting | Daytime running lamp | Headlamp | Headlight styling | Hidden headlamps | Retroreflector | Sealed beam | Trafficators | High intensity discharge |
| Other | British car number plates | Distance sensor | US and Canadian license plates | Vanity plate | Vehicle registration plate | Windscreen wiper | Windshield washer fluid | |
| Car engine | Air/Fuel | Air filter | Automatic Performance Control | Blowoff valve | Boost | Boost controller | Butterfly valve | Carburetor | Charge cooler | Centrifugal type supercharger | Cold air intake | Engine management system | Engine Control Unit | Forced induction | Front mounted intercooler | Fuel filter | Fuel injection | Fuel pump | Fuel tank | Gasoline direct injection | Indirect injection | Intake | Intercooler | Manifold | Manifold vacuum | Mass flow sensor | Naturally-aspirated engine | Ram-air intake | Scroll-type supercharger | Short ram air intake | Supercharger | Throttle body | Top mounted intercooler | Turbocharger | Turbocharged Direct Injection | Twin-turbo | Variable Length Intake Manifold | Variable geometry turbocharger. Warm air intake |
| Exhaust | Catalytic converter | Emissions control devices | Exhaust pipe | Exhaust system | Glasspack | Muffler | Oxygen sensor | |
| Cooling | Aircooling | Antifreeze | Ethylene glycol | Radiator | Thermostat | |
| Ignition system | Starter | Car battery | Contact breaker | Distributor | Electrical ballast | Ignition coil | Lead-acid battery | Magneto | Spark-ignition | Spark plug | |
| Other | Balance shaft | Block heater | Crank. Cam | Camshaft | Connecting rod | Combustion chamber | Crank pin | Crankshaft | Crossflow cylinder head | Crossplane | Desmodromic valve | Engine knocking | Compression ratio | Crank sensor | Cylinder | Cylinder bank | Cylinder block | Cylinder head | Cylinder head porting | Dump valve,Engine balance | Oil filter | Firing order | Freeze plug | Gasket | Head gasket | Hypereutectic piston | Hydrolock | Lean burn | Main bearing | Motor oil | Multi-valve | Oil sludge | Overhead camshaft | Overhead valve | PCV valve | Piston | Piston ring | Pneumatic valve gear | Poppet valve | Power band | Redline | Reverse-flow cylinder head | Rocker arm | Seal | Sleeve valve | Starter ring gear | Synthetic oil | Tappet | Timing belt | Timing mark | Top dead centre | Underdrive pulleys | Valve float | Variable valve timing | |
| Interior equipment | Instruments | Backup camera | Boost gauge | Buzzer | Car computer | Carputer | Check Engine light | Fuel gauge | Global Positioning System | Idiot light | Navigation system | Odometer | Speedometer | Tachometer | Trip computer |
| Controls | Bowden cable | Cruise control | Electronic throttle control | Hand brake | Manettino dial | Steering wheel | Throttle | Gear stick | |
| Motor vehicle theft deterrence | Car alarm | ESITrack | Immobiliser | Klaxon | Vehicle tracking system | VIN etching | |
| Passenger safety & seating | Airbag | Armrest | Automatic seatbelt | Bench seat | Bucket seat | Child safety lock | Dicky seat | Passive safety | Rumble seat | Seat belt | |
| Other | Air conditioning | Ancillary power | Car audio | Car phone | Center console | Dashboard | Motorola connector | Power window | Rear-view mirror | TripSense | |
| Powertrain | Wheels and Tires | All-terrain tyre | Bias-ply tire | Contact patch | Custom wheel | Drive wheel | Hubcap | Magnesium alloy wheel | Mud-terrain tyre | Paddle tires | Radial tire | Rostyle wheel | Run flat tires | Schrader valve | Slick tire | Spinner | Tire code | Tread | Treadwear rating | Whitewall tire | Wire wheels |
| Transmission | Automatic transmission | Clutch | Continuously variable transmission | Differential | Driveshaft | Electrorheological clutch | Epicyclic gearing | Fluid coupling | Fully-automatic transmission | Gear stick | Gearbox | Hydramatic | Limited slip differential | Locking differential | Manual transmission | Roto Hydramatic | Saxomat | Semi-automatic transmission | Semi-automatic transmission | Super Turbine 300 | Tiptronic Torque converter | Transmission (mechanics) | Transmission Control Unit | Turbo-Hydramatic | Universal joint | |
| Steering | Ackermann steering geometry | Anti-lock braking system | Camber angle | Car handling | Caster angle | Oversteer | Power steering | Rack and pinion | Toe angle | Torque steering | Understeer | |
| Suspension | Axle | Beam axle | Coil spring | De Dion tube | Double wishbone | Electronic Stability Control | Hydragas | Hydrolastic | Hydropneumatic suspension | Independent suspension | Kingpin | Leaf spring | Live axle | MacPherson strut | Multi-link suspension | Panhard rod | Semi-trailing arm suspension | Shock absorber | Sway bar | Swing axle | Torsion beam suspension | Transaxle | Trailing arm | Unsprung weight | Watt's linkage | Wishbone suspension | |
| Brakes | Anti-lock braking system | Disc brake | Drum brake | Hand brake | Hydraulic brake | Inboard brake | Brake lining | Brake fade | Brake fluid | Hydraulic fluid | Brake bleeding | Engine braking | Electronic brakeforce distribution | Regenerative brake |
